Building the roof of a house is just important as other work while building a house. A roof of a house is much more than just the decorative top. A roof is built to prevent sunlight and rain, it also helps to drain water away from a structure, and provides insulation that helps keep the interior of a building warm or cool, depending on the season. Roof building is not a small and easy work to do. Perfect measurement and planning are needed to make a perfect roof.

When you are done with measurement and planning, you have to buy materials now. Choose the perfect and long-lasting material. The time you have collected all your material its time now to build a roof for your house. At the very first you have to make the frame with trusses. The wall frames, where trusses are going to be attached must already be level, plumb, and square. You can use ladders or scaffolding if the building is also just framed or not prepared fully. It would be better if you use a crane to get help. Before you can install the trusses, you have to install temporary braces so that the trusses can rest on until the sheathing and permanent bracing are getting installed. At the center of the back wall, nail the bottom half of a board to the top of the outside wall. Make sure you have fastened it to a stud. Repeat the same steps to install all temporary braces at the front of the building as well. Install the two end trusses at the front and back of the building according to the manufacturer’s instructions, making sure you have fixed them to the temporary bracing. It will make the trusses more strong. Then install the standard trusses. Once all the trusses are installed, install permanent bracing as per the truss manufacturer’s instructions. the next thing you have to do is sheathing the roof. while you sheath the roof, keep that in mind that you have to join panels over supports, and ensure that panels are one-eighth of an inch apart from each other. Repeat the same possess for both sides of the roof. After that install the drip edge. This will protect the bottom of the sheathing from rain and direct it into a gutter or away from the house.

After that install the underlayment. The most common underlayment is roofing felt, felt uses asphalt instead of tar. The main purpose of the underlayment is waterproofing. Underlayment will keep you safe from rain. You will be dry inside while its raining outside. Similar to sheathing and underlayment, the roof cover is installed from the bottom up. Like underlayment, they should also overlap. So when it rains the water drains away.


Following the steps above you can make a roof perfectly. Follow step by step to avoid any kind of mistakes. Because a single mistake can ruin the whole work.

Factors to Consider When Choosing Decking Materials

A deck is usually constructed outside the house and will, therefore, be subjected to adverse climatic conditions which are sometimes too hot or too cold. It is also a focus point to anyone coming to visit and even passersby as it will be the first thing that they will see when they get into your compound. You should, therefore, ensure that the deck will present a good image of your house and creates a homely atmosphere. A deck is place where you unwind after a hard day at work and will need careful consideration before you begin the construction.

Below are some of the factors you should consider when selecting decking materials:

  • Location: consider the place you intend to locate the deck before you buy the material. It could be at the back of the house where there is a lot of exposure to the sun or a place where there is shade.

A deck that is exposed to sunshine will be exposed to massive heating and will need a material that will not get very hot to make a person stepping on it barefoot get burnt. Such a deck will also be prone to fading or even warping as a result of the heat. A wooden material will be the ideal choice for a deck in this location. It should be painted with a light color that will not absorb a lot of heat.

If the deck will be placed in an area with a lot of shade, it could develop moulds or even stains and will need cleaning several times. You can choose a composite material for this location as it is not easily stained, warped, and hardly rot.

  • Maintenance cost: Every deck will at one time need cleaning which is usually done annually. A wooden deck will however require re-staining and also prepped after every two or three years. To eliminate fading, wooden decks also require annual finish application which is not the case with composite decks. This makes wooden decks more expensive to maintain than the composite decks.


  • Cost of purchase: A composite deck is more expensive to construct than a wooden deck and will also require a lot of structural support during construction.

Composite decks are long lasting and have less maintenance cost and will therefore be ideal if you intend to stay in that house for a long time. If you intend to shift after a few years, you would go for a wooden deck.

  • Pest infestation: wood is usually prone to destruction by carpenter bees which could even drill the wood to make nests. Composite decks are safe from such pests as they cannot penetrate through the hard material.
  • Aesthetic appeal: Personal preference is also a consideration when selecting decking materials. If you prefer to go natural, you would go for wood; for a person who loves a more finished look, he would go for composite.

Choosing materials for building your deck is mostly driven by personal preference and the budget you have allocated to the deck construction. Consider a choice that will cost you less to maintain and one that will best suit the location of your deck. Do not use untreated wood that will be prone to pests as this will make your deck last for a short time and you will have to incur a lot of costs to repair. You should also choose a location that will provide a relaxing atmosphere where there is neither too much sunshine nor too much cold.


If you need an expert in the business, call Ogden Decks who has been in the business for 20+ years.



Snow Removal

Snowfall is beautiful. People enjoy snowfall a lot. But when snow falls too much and becomes snow removal it can cause many unwanted problems in daily life. When its snow-falling too much roads get blocked with ice.  Vehicles can hardly move from one place to another. Chances of accident increases as the road gets slippery and tire loses grip from the ground. If you live in a place where it snows, you might know how it feels to see everything blocked by snow. Who wants to wake up in the morning and see snow blocking their door? Definitely no one! Government and other institution work to remove the snow from the road. But what about the snow on your property and the sidewalk? You have to remove that snow by yourself. Snow and ice removal can be back-breaking work. But there are some tools to ease this problem of many home and car owners existence each winter.

Snow shovel can help you. A snow shovel is used to move snow easily. Though using a snow shovel can cause health damage but it can be useful to health if used properly. It’s a cheap way to clean and remove snow from your property. Using a snow shovel you don’t have to take snow and then put that away carrying it. But with a normal shovel, you have put a lot of hard work after the same work. So the snow shovel makes snow removal easy and time-saving. Some people use a special type of shovel which can be attached to a car, so then they use the can as a snow removing vehicle and easily remove snow from their lawn and driveway.

On the other hand, you can use a snow blower. A snow blower or snow thrower is a machine for removing snow from an area where it is not wanted, such as a sidewalk, roadway, railway track. It just pulls snow into the machine and throws the snow any direction you want. there are several types of snow blowers. Some of them use electricity and others need diesel or gasoline. A snow blower is both cheap and expensive it depends on you if you need a heavy one or a light one. Maximum people would recommend buying a light one which is easy to use and takes less space.  Nowadays there are some chemicals in the market which melts snow faster than usual methods. It is really useful if you have no time or don’t want to work hard. But there are some problems with this method of snow removal. But chemicals need to be selected and applied with care. Excessive use of chemicals can also cause different problems like soil erection, air pollution and can be deadly for trees and nature.

Though heavy snowfall is a great problem we cant just do several harmful things just to clear snow. So it is better not to use chemicals and relative stuff.

You should be extra careful while you are removing snow or ice. Because it’s too slippery than usual. You can wear extra wool socks on the shoe to prevent slipping. Get a help of a second person if possible it will make the work easier.